Guides for Camberley homeowners
Planning a media wall: what to decide before any timber is cut
A media wall looks simple. A screen, a fire, a few shelves. The simplicity is the result of a dozen decisions made early, most of them hidden once the wall is finished.
Get them right and you have a wall you enjoy for years. Get them wrong and you are cutting into fresh plaster to reach a cable.
Decide what it has to hold
Write a list of everything that will live in or on the wall. The television and its exact model. A soundbar. A set-top box, a games console, a router. An electric fire, if you want one.
Buy or at least choose the television and the fire first. The openings are built round their real sizes, with the clearances the makers ask for. A wall built for a 55 inch screen will not take a 65 later without rebuilding the recess.
Think about what else you want from the wall. Closed cupboards for games and controllers? Open niches with lighting? Logs, books, nothing at all?
Screen height: lower than you think
The common mistake is putting the screen too high, as if it were a picture over a mantelpiece. You then watch with your chin up, and your neck tells you about it.
Sit on your own sofa and look straight ahead. The middle of the screen should be close to that eye line, or a little above. With a fire underneath, there is a tension between the two. A long, low fire helps keep the screen down.
Mark the outline on the wall with masking tape and live with it for a few evenings before anyone builds anything.
Depth, heat and air
The wall has to be deep enough for the deepest item, usually the fire. That depth comes out of your room, so check it against the sofa position and the door swing.
Electronics make heat. So do electric fires, which blow warm air from the front. A television shut tight in a recess above a heater, with boxes sealed in a cupboard below, runs hot. Follow the fire maker's instructions on clearances to the screen and to any timber.
A carpenter can build in discreet ventilation: a gap at the top of a cupboard, a grille in the plinth, an open back to a void. Ask how the heat gets out.
Wiring and getting back in
- Sockets behind the screen and in each cupboard, so no lead trails down the wall
- A conduit, which is a wide plastic tube, between the screen recess and the cupboard, so cables can be pulled through and swapped in future
- An aerial or network point where the boxes will sit
- A panel or cupboard back that lifts off, so someone can reach the wiring without tools and dust
- A switched supply for the fire and for any lighting
The electrical work should be done by a qualified electrician, and it is planned with the carpenter so the frame leaves room for it.
Who does what
The carpenter builds the timber frame, fixes the board, makes the recesses and fits any cabinets and shelves. The electrician wires it. If the wall is to look like part of the room, a plasterer skims it and a decorator paints it. If it is to look like furniture, the carpenter finishes it in painted or timber-faced panels instead.
Some carpenters bring the other trades and give one price. Ask, so you are not left booking a plasterer yourself halfway through.
What the guides say a media wall costs
The media wall cost guide, last updated in September 2026, gives £2,000 to £4,000 or more for a standard media wall, supplied and installed. With a fireplace built in, it gives £2,300 to £3,500, with an average of £2,800.
The same guide prices a plain false wall at £55 to £65 a square metre, and says that figure includes plastering, skirting and electrics. It adds that a media wall with a fire typically runs £500 to £1,000 more than one without.
These are national figures for typical walls. The long lounge wall of a larger Camberley house may well be wider than typical. More on the service itself is on the alcove units and media walls page.
Common questions
Can a media wall go on an outside wall?
Yes, but ask about damp and insulation first. Building a sealed timber frame against a cold outside wall can trap moisture behind it. A carpenter may leave an air gap or add insulation, and will want to know the wall is dry to begin with.
Does a media wall need building regulations approval?
The joinery does not normally. New electrical circuits and sockets must meet the wiring rules, which is why an electrician does that part. If you plan a gas or solid fuel fire, the rules are stricter and you need a suitably registered installer. An electric fire is the usual choice in a media wall for that reason.
Mark it out on the wall first
The planning costs nothing and saves the most. A screen built in at the wrong height, or cables sealed behind plaster, stays wrong until someone pays to rebuild it.
Send the wall width, the screen size and if you want a fire. Add your area around Camberley.